Concrete release agent for pipe pile

• Industry：

  Tielongbao concrete release agent is applicable to cement pre products with low requirements for concrete appearance quality, steel formwork, wood formwork, etc. Its principle is that after the formwork coated with release agent is dry, a layer of film can be formed on the surface of the formwork, and its adhesion to the concrete is far less than its adhesion to the formwork, which can form the effect of smooth product surface after concrete pouring.
  ★ function and characteristics
  1. Protect the formwork, with excellent anti-corrosion and rust resistance, and prolong the service life of the formwork;
  2. It can improve the quality of concrete surface and make the formed concrete surface smooth, delicate, marble like, bright and plump;
  ★ instructions for use
  1. Brush coating (recommended): apply with a brush and pay attention to the uniformity. The concrete construction can only be carried out after the formwork agent forms a film and is dry. If it is not dry, the formwork agent will adhere to the slurry, resulting in the flower on the concrete surface and the difficulty of formwork removal;
  ⒉. Spraying: use a general paint spray gun with a nozzle of 0.5 ~ 1mm, and the air pump pressure during spraying is 0.6 ~ 0.8MPa;
  ★ consumption
  Steel formwork and wood formwork can be brushed with about 22 square meters per kilogram, and the spraying process can be sprayed with 26-32 square meters per kilogram; If it is a pure wood mold, brush about 8 square meters per kilogram, and spray 7-12 square meters per kilogram.
  ★ precautions
  1. The release agent shall be sealed and stored to prevent water seepage and air leakage, and the used shall not be mixed with the unused;
  ⒉. Before construction, the surface of the formwork shall be free of floating rust, oil stain and impurities, and the formwork surface shall have a certain roughness. Polishing treatment is not allowed, and it is best to grind the texture with fine sandpaper. The surface treatment of formwork directly affects the use effect. 3 The membrane shall not be washed by rain before it is dry, otherwise it may bubble; In case of wet and rainy weather, please cover it with canvas to prevent the film from washing away. If it gets wet accidentally, apply it again.
  4. If the temperature is lower than 10 ℃, add water to heat up to 30 ℃ and turn it on for use.
  ★ technical indicators
  Net weight: 20okg.
  Appearance: Opal liquid, no mechanical impurities. PH value: 6.0 ~ 8.0
  Stability: 3000 / min, no hair layer for 15min.
  This product is non-toxic, non corrosive, non combustible and non dangerous.